Powerfix PDM 250 A1 Manuel d'utilisateur télécharger pdf (Page 12)

POWERFIX PDM 250 A1

10 - English

Inserting/changing the battery

The multimeter is powered by a 9V battery. To insert or replace the battery, proceed as follows:

Switch off the multimeter and remove all test leads before opening the multimeter!

If the battery is exhausted, the

icon appears on the display [1]. The battery should be

replaced as soon as possible to ensure that the multimeter continues to work properly.

 Remove the holster [2].

 Remove the two screws on the back of the multimeter and remove the back panel.

 Connect the 9V battery with the correct polarity (note + and –) to the battery clip and place

the 9V battery in the battery compartment.

 Replace the back panel and screw it tight with the two screws.

 Re-insert the multimeter in the holster [2].

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 107 108

Pas de commentaire

Powerfix PDM 250 A1 Manuel d'utilisateur Page 12