Powerfix PLS 10 A1 Manuel d'utilisateur télécharger pdf (Page 38)

Powerfix PLS 10 A1

36 - English

mounting bracket (3) from the top into the thread of the stand (5) and rotate it clockwise (see

the figure). Tighten the knurled screw (4) so the mounting bracket (3) firmly fixes to the

stand (5).

Charging the battery

The DC-IN socket (8) is protected against humidity with a rubber cover (7). To release this

rubber cover (7), pull the red latch. Then connect the wall plug battery charger (B) charging

plug to the battery LED emitter (A) DC-IN socket (8), and connect the wall plug battery

charger (B) to an easy-accessible mains outlet. Before using the device for the first time, fully

charge the built-in Li-Ion battery. During charging, the charge indicator (6) lights red. When

the built-in Li-Ion battery is fully charged, the charge indicator (6) changes to green. Unplug

the wall plug battery charger (B) from the mains outlet and then disconnect the wall plug

battery charger (B) plug from the DC-IN socket (8). Close the DC-IN socket (8) with the

rubber cover (7). Now the battery LED emitter (A) is ready for use.

Note: If the charge indicator (6) flashes in red while using the battery LED emitter (A), the

built-in Li-Ion battery is almost empty. In this case, recharge the battery.

Getting started

You can use the two knurled screws (10) to adjust the vertical angle and therefore the beam

of the battery LED emitter (A). Release the knurled screws (10) by rotating them 360 degrees

counter-clockwise. Next adjust the vertical angle of the battery LED emitter (A) according to

your needs. Then tighten the two knurled screws (10).

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 59 60

Pas de commentaire

Powerfix PLS 10 A1 Manuel d'utilisateur Page 38