Powerfix PBUH 1.5 A1 Manuel d'utilisateur télécharger pdf (Page 24)

PBUH 1.5 A1

Measurement of constructional material or wood moisture

♦ Switch the appliance on by pressing the ON/SET button.

♦ Before taking the ﬁ rst measurement, check that the appliance is functioning

corr

ectly. For this, use the test aid

. On the test aid there are four

measurement points marked as and .

♦ Press the measuring pins on the measurement points . All measurement

lines on the display

begin to blink.

♦ Now press the measuring pins

on the measurement points . The measuring

lines on the display

should now be showing 19% (+/- 1%).

♦ When you arrive at the given value in both tests, the appliance is ready for use.

♦ Press the measuring pins

into the material to be tested. The measurement

lines on the display

show the moisture content.

♦ To read the result for ﬁ rewood, cardboard and construction timber, use the

lef

t scale with the symbol

♦ To read the results for mortar, concrete and plaster, use the right scale with

the symbol

♦ If the measured value exceeds the maximum values of 2% resp. 44%, the

measur

ement lines start to blink.

♦ To minimise measurement errors, carry out comparative measurements at

veral locations.

Temperature Display

♦ The temperature is indicated at the top of the display .

♦ Press and hold the ON/SET

button for 3 seconds to toggle between

Celsius and Fahrenheit.

Pocket lamp

♦ Press and hold the button for 3 seconds to switch the LED on.

♦ Press the button

once again to switch the LED oﬀ .

Automatic switch-oﬀ

The appliance switches itself oﬀ automatically after approx. 30 seconds without

button activation. The automatic switch oﬀ is disabled when the LED

switched on.

Buch_75094_LB1.indb 21 14.06.12 15:54

1 2 ... 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Powerfix PBUH 1.5 A1 Manuel d'utilisateur Page 24

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Powerfix PBUH 1.5 A1